Huben

Huma-Air Huben K1 Tuning Regulator

This unique regulator is specially designed as a "one on one" replacement regulator for the BSA R10 rifles and solves all your regulator problem instantly!
It can be screwed into the action within a minute. It fit’s all models.
The regulator is vented to the atmosphere, so no creeping up in power in long term.

The regulator is very consistent over the total pressure range of the buddy bottle and solves all the known issues of the original regulator.
Made of high grade aircraft aluminium in combination with  CR42 molybdeen steel.

Designed for a wide pressure range (70-150 bar) to suit sub 12 ft/lbs (UK) and  high power FAC models.
 

The benefits:

Higher accuracy of your rifle due to the elimination of the pelletspeed fluctuations
A constant pellet speed over the full working pressure range.
It will give you a better shotcount and a full flat shotstring immediately.


Pressure settings

The regulator comes preset on the most common pressure setting according to your choise of barrel and caliber, or we will adjust it according to your personal wishes.
The length of the barrel is measured from the magazine until the tip of the actual barrel (not the end of the shroud)
After fitting the regulator, always check the powersetting of the rifle and finetune it when needed to stay within legal limits.


When you order one of our regulators you will receive:

• Your regulator preset on to your own wishes;
• We will include a “Huma regulated” breech sticker;
• Fitting instructions as pdf download

 
Quality

The regulator is CNC produced out of high grade aircraft Aluminum and bronze.
To guarantee a perfect product, every regulator is manually assembled, tested and adjusted to the requested pressure. 
We only use belleville springs designed for critical applications to achieve the highest repeat accuracy. This gives our regulators a repeat cycle less than 1% difference.